FANDOM



MCT246
150px
IC Title CANNON
Type 3ISO
Inputs 3
Outputs 1
Restricted Yes
Added CBX v10.0


Shoots a Ghast's fireball. Works the same as [MCX246], except this can adjust the rotation and pitch through the left and right redstone wire inputs.

File:MCT246.png
Left input decreases value.
Right input increases value.
Front input shoots.
When the lever on top of block is in the "off" position, the rotation value will be changed by the left and right inputs.
When the lever on top of the block is in the "on" position, the pitch value will be changed.
The direction the lever on top is facing does not matter.

Sign SettingsEdit

Quick ReferenceEdit

line 1 <blank>
line 2 [MCT246]
line 3 speed
line 4 rotation:pitch
green text = OPTIONAL
everything else = REQUIRED

DetailsEdit

  • Line 3:
    speed is the speed for the launched fireball. Speed must be between 0 and 5. If left blank, the speed will be set to 0.2. NOTE Faster speeds tend to make the fireball harder to see (since it's going fast) and can cause it to explode sooner. It is recommended to keep the speed less than 1.


  • Line 4:
    rotation:pitch is the left/right rotation and up/down pitch of the fireball. If left blank, the rotation and pitch will both be set to 0.
    rotation - Sets the left/right direction the fireball should go. The value must be a number from -90 to 90. Where -90 is left, 90 is right, and 0 is center.
    pitch - Sets the up/down direction the fireball should go. The value must be a number from -1 to 1. Where -1 is down, 1 is up, and 0 is center.

InputsEdit

File:IC input123.png
A / 1: Shoot
When the input is toggled on, it will shoot a single fireball.
B / 2: Decrease value
When the input is toggled on, the set value will decrease. The set value is either the rotation or the pitch depending on the on/off state of the lever on top of the IC block.
C / 3: Increase value
When the input is toggled on, the set value will increase. The set value is either the rotation or the pitch depending on the on/off state of the lever on top of the IC block.

OutputsEdit

File:IC output.png

none


Optional ModesEdit

none

ExamplesEdit

BasicEdit

Basic sign setup.

1
2 [MCT246]
3
4


With a Faster SpeedEdit

1
2 [MCT246]
3 2
4


Shooting to the LeftEdit

The rotation value can later be changed with the left and right restone wire inputs

1
2 [MCT246]
3
4 -90


Shooting UpwardEdit

The pitch value can later be changed with the left and right restone wire inputs. A lever will need to be on top of the IC block and set on.

1
2 [MCT246]
3
4 0:1


Shooting Downward and a little to the RightEdit

1
2 [MCT246]
3
4 30:-0.2


GalleryEdit

BugsEdit

See AlsoEdit